8.1.3 VLAN Config
Multicast groups established by IGMP Snooping are based on VLANs. On this page you can
configure different IGMP parameters for different VLANs.
Choose the menu Multicast→IGMP Snooping→VLAN Config to load the following page.
Figure 8-6 VLAN Config
The following entries are displayed on this screen:
VLAN Config
VLAN ID: Enter the VLAN ID to enable IGMP Snooping for the desir
Router Port Time:
Specify the aging time of the router port. Within this time, if the
switch doesn’
t receive IGMP query message from the router
port, it will consider this port is not a router port any more. By
default, it is 0 and the global router-time will be used.
Member Port Time:
Specify the aging time of the member port. Within this time, if
the switch doesn’
t receive IGMP report message from the
member port, it will consider this port is not a member port any
more. By default, it is 0 and the global member-time will be used.
Router Ports:
Specify the static router port which is mainly used in the
network with stable topology.
Static Router Ports
UNIT:1/LAGS: Click 1 to configure the physical ports. Click LAGS
to configure
the link aggregation groups.
98
To Next Page
Loading...
