TP-Link JetStream T1500G-10MPS - System IP

The following entries are displayed on this screen:

DST Config
DST Status:
Enable or disable the DST.
Predefined Mode: Select a predefined DST configuration.
 USA: Second Sunday in March, 02:00 to
First Sunday in
November, 02:00.
 Australia: First Sunday in October, 02:00 to
First Sunday in
April, 03:00.
 Europe: Last Sunday in March, 01:00 to
Last Sunday in
October, 01:00.
 New Zealand: Last Sunday in September, 02:00 to
First
Sunday in April, 03:00.
Recurring Mode:
Specify the DST configuration in recurring mode. This
configuration is recurring in use.
 Offset: Spe
cify the time adding in minutes when Daylight
Saving Time comes.

Start/End Time: Select starting time and ending time of
Daylight Saving Time.
Date Mode: Specify the DST configuration in Da
te mode. This configuration
is recurring in use.
 Offset: Specify t
he time adding in minutes when Daylight
Saving Time comes.

Start/End Time: Select starting time and ending time of
Daylight Saving Time.
Note:
1. When the DST is disabled, the predefined mode, recurring mode and date mode cannot be
configured.
2. When the DST is enabled, the default daylight saving time is of European in predefined
mode.
4.1.5 System IP
Each device in the network possesses a unique IP Address. You can log on to the Web
management page to operate the switch using this IP Address. The switch supports three
modes to obtain an IP address: Static IP, DHCP and BOOTP. The IP address obtained using a
new mode will replace the original IP address. On this page you can configure the system IP of
the switch.
20