TP-Link JetStream T1500G-10MPS - Event

Index:
Displays the index number of the entry.
Port:
Specify the port from which the history samples were taken.
Interval:
Specify the interval to take samplings from the port.
Max Buckets:
Displays the maximum number of buckets desired for the RMON
history group of statistics, ranging from 1 to 130. The default is
50 buckets. 130 buckets supported at most so far.
Owner:
Enter the name of the device or user that defined the entry.
Status:
Select Enable/Disable the corresponding sampling entry.
13.3.3 Event
On this page, you can configure the RMON events.
Choose the menu SNMP→RMON→Event to load the following page.
Figure 13-11 Event Config
The following entries are displayed on this screen:

Event Table
Select:
Select the desired entry for configuration.
Index:
Displays the index number of the entry.
User:
Enter the name of the User or the community to which the
event belongs.
Description:
Give a description to the event for identification.
Type:
Select the event type, which determines the act way of the
network device in response to an event.
• None: No processing.
•
Log: Logging the event.
199