Transmit Delay: Enter a value from 1 to 8192 in seconds t
o specify the time for
the local device to transmit LLDPDU to its neighbors after
changes occur so as to prevent LLDPDU being sent frequently.
The default value is 2.
Reinit Delay:
This parameter indicates the amount of delay from when LLDP
status becomes "disable" until re-
initialization will be attempted.
The default value is 3.
Notification
Interval:
Specify the interval of Trap message which will be sent from
local device to network management system.
Fast Start Times: When th
e port's LLDP state transforms from Disable (or
Rx_Only) to Tx&Rx (or Tx_Only), the fast start mechanism will be
enabled, that is, the transmit interval will be shorten to a second,
and several LLDPDUs will be sent out (the number of LLDPDUs
equals this parameter). The default value is 3.
14.1.2 Port Config
On this page you can configure all ports' LLDP parameters.
Choose the menu LLDP→Basic Config→Port Config to load the following page.
Figure 14-2 LLDP Port Config
208
To Next Page
Loading...
