TP-Link JetStream T1500G-10MPS - Voice VLAN Configuration

The following entries are displayed on this screen:
 Storm Control Config
UNIT:1/LAGS:
Click 1 to configure the physical ports. Click LAGS
to configure
the link aggregation groups.
Select:
Select the desired port for Storm Control configuration. It is
multi-optional.
Port:
Displays the port number of the switch.
Broadcast Rate
Mode:
Select the broadcast rate mode, kbps or ratio.
 kbps: Specify the threshold in kbits per second.
 ratio
: Specify the threshold as a percentage of the
bandwidth.
Broadcast:
Select the bandwidth for receiving broadcast packets on the
port. The packet traffic exceeding the bandwidth will be
discarded. Select Disable to disable the
broadcast control
feature on the port.
Multicast Rate
Mode:
Select the multicast rate mode, kbps or ratio.
 kbps: Specify the threshold in kbits per second.
 ratio
: Specify the threshold as a percentage of the
bandwidth.
Multicast:
Select the bandwidth for receiving multicast packets on the
port. The packet traffic exceeding the bandwidth will be
discarded. Select Disable to
disable the multicast control
feature on the port.
UL-Frame Rate
Mode:
Select the UL-Frame rate mode, kbps or ratio.
 kbps: Specify the threshold in kbits per second.
 ratio
: Specify the threshold as a percentage of the
bandwidth.
UL-Frame: Select the bandwidth for receiving UL-
Frame on the port. The
packet traffic exceeding the bandwidth will be discarded.
Select Disable to disable the UL-
Frame control feature on the
port.
LAG:
Displays the LAG number which the port belongs to.
Note:
If you enable storm control feature for the ingress rate limit-enabled port, ingress rate limit
feature will be disabled for this port.
9.3 Voice VLAN
121