Kensington Security Slot
Secure the lock (not provided) into the security slot to prevent the device from being stolen.
Power Socket
Connect the female connector of the power cord here, and the male connector to the AC
(Alternating Current) power outlet. Please make sure the voltage of the power supply meets
the requirement of the input voltage.
Grounding Terminal
The switch already comes with lightning protection mechanism. You can also ground the
switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable.
T1500G-8T
The rear panel of T1500G-8T features a power socket, 8 10/100/1000Mbps Ethernet ports and
a Kensington Security Slot.
Figure 2-5 Rear Panel of T1500G-8T
Power Socket
Connect the power socket and AC (Alternating Current) power outlet with the provided DC
power adapter and AC power cord. Please make sure the voltage of the power supply
meets the requirement of the input voltage.
Port 1-8
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps.
Each has a corresponding LED.
Please note that port 8 is a PD (Powered Device) port that supports being powered by a PSE
(Power Sourcing Equipment) complying with 802.3af standard. The DC power input takes
precedence over the PD port. If the DC input fails, the PoE input on the PD port will supply
power to the switch instead.
T1500G-10PS
The rear panel of T1500G-10PS features a power socket, 8 10/100/1000Mbps Ethernet ports
and 2 SFP transceiver ports.
12
To Next Page
Loading...
