TP-Link JetStream T1500G-10MPS - Page 97

Step
Operation
Description
2 Enable STP function On Spanning Tree→STP Config→STP Config page,
enable STP function and select MSTP version.
On Spanning Tree→STP Config→Port Config page,
enable MSTP function for the port.
3 Configure the region name and
the revision of MST region
On Spanning Tree→MSTP Instance→Region Config
page, configure the region as TP-Link and keep the
default revision setting.
4 Configure VLAN-to-Instance
mapping table of the MST
region
On Spanning Tree→MSTP Instance→Instance
Config page, configure VLAN-to-Instance mapping
table. Map VLAN 101, 103 an
d 105 to Instance 1;
map VLAN 102, 104 and 106 to Instance 2.
 Configure Switch B:
Step
Operation
Description
1 Configure ports On VLAN→802.1Q VLAN
page, configure the link
type of the related ports as Tagged, and add the
ports to VLAN101-VLAN106. The detailed
instructions can be found in the section
802.1Q
VLAN.
2 Enable STP function On Spanning Tree→STP Config→STP Config page,
enable STP function and select MSTP version.
On Spanning Tree→STP Config→Port Config page,
enable MSTP function for the port.
3 Configure the region name and
the revision of MST region
On Spanning Tree→MSTP Instance→Region Config
page, configure the region as TP-Link and keep the
default revision setting.
4 Configure VLAN-to-Instance
mapping tab
le of the MST
region
On Spanning Tree→MSTP Instance→Instance
Config page, configure VLAN-to-Instance mapping
table. Map VLAN 101, 103 and 105 to Instance 1;
map VLAN 102, 104 and 106 to Instance 2.
5 Configure switch B as the root
bridge of Instance 1
On Spanning Tree→MSTP Instance→Instance
Config page, configure the priority of Instance 1 to
be 0.
6
Configure switch B as the
designated bridge of Instance
2
On Spanning Tree→MSTP Instance→Instance
Config page, configure the priority of Instance 2 to
be 4096.
87