TP-Link JetStream T1500G-10MPS - Page 99

Step
Operation
Description
4 Configure VLAN-to-Instance
mapping table of the MST
region
On Spanning Tree→MSTP Instance→Instance
Config page, configure VLAN-to-Instance mapping
table. Map VLAN101, 103
and 105 to Instance 1;
map VLAN102, 104 and 106 to Instance 2.
 The configuration procedure for switch E and F is the same with that for switch D.
 The topology diagram of the two instances after the topology is stable
 For Instance 1 (VLAN101, 103 and 105), the red paths in the following figure are connected
links; the gray paths are the blocked links.
 For Instance 2 (VLAN102, 104 and 106), the blue paths in the following figure are connected
links; the gray paths are the blocked links.
 Suggestion for Configuration
 Enable TC Protect function for all the ports of switches.
 Enable Root Protect function for all the ports of root bridges.
89