70
4.5 Configure LED
You can turn on or off the LED light of the EAP and flash the LED to locate your device.
To configure LED, go to the Management > LED Control page.
Check the box to turn on or turn off the LED light of the EAP, and click Save. To flash the
LED, click Locate. Then the LED will flash for 10 minutes or until the locate button is clicked
again.
4.6 Configure Wi-Fi Control
(Only for Certain Devices)
Note:
Wi-Fi Control is only available on certain devices. To check whether your device supports this
feature, refer to the actual web interface. If Wi-Fi Control is available, there is Management > Wi-Fi
Control in the menu structure.
To Next Page
Loading...
