TP-Link T1700G-28TQ - Page 136

126
Choose the menu Multicast→IGMP Snooping→Multicast VLAN to load the following page.
Figure 9-8 Multicast VLAN
The following entries are displayed on this screen:

Multicast VLAN
Multicast VLAN: Select Enable/Disable Multicast VLAN feature.
VLAN ID: Enter the VLAN ID of the multicast VLAN.
Router Port Time: Specify the aging time of the router po
rt. Within this time, if the
switch doesn’
t receive IGMP query message from the router port,
it will consider this port is not a router port any more.
Member Port Time:
Specify the aging time of the member port. Within this time, if the
switch doesn’t rec
eive IGMP report message from the member
port, it will consider this port is not a member port any more.
Dynamic Router
Ports:
Displays the dynamic router ports of the multicast VLAN.
Static Router Ports: Specify the static router port which is mainly
used in the network
with stable topology.
Note:
1. The router port should be in the multicast VLAN, otherwise the member ports cannot receive
multicast streams.
2. The Multicast VLAN won't take effect unless you first complete the configuration for the
corresponding VLAN owning the port on the 802.1Q VLAN page.