TP-Link T1700G-28TQ - Ping; Tracert

243
15.4.1 Ping
Ping test function, testing the connectivity between the switch and one node of the network,
facilitates you to test the network connectivity and reachability of the host so as to locate the
network malfunctions.
Choose the menu Maintenance→Network Diagnostics→Ping to load the following page.
Figure 15-8 Ping
The following entries are displayed on this screen:

Ping Config
Destination IP
: Enter the IP address of the destination node for Ping test.
Both IPv4
and IPv6 are supported.
Ping Times
:
Enter the amount of times to send test data during Ping testing. The
default value is recommended.
Data Size
:
Enter the size of the sending data during Ping testing. The default
value is recommended.
Interval
:
Specify the interval to send ICMP request packets. The default value
is recommended.
15.4.2 Tracert
Tracert test function is used to test the connectivity of the gateways during its journey from the
source to destination of the test data. When malfunctions occur to the network, you can locate
trouble spot of the network with this tracert test.