TP-Link T1700G-28TQ - Profile Binding

144
Operation: Click the Edit
button to configure the mode or
IP-range of the Profile.
After you have created a profile ID, click Edit to display the following figure.
The following entries are displayed on this screen:

Profile Mode
Profile ID: Displays the Profile ID you have created.
Mode: Displays the attribute of the profile.
 Permit
: Only permit the IP address within the IP range and
deny others.
 Deny
: Only deny the IP address within the IP range and permit
others.

Add IP-range
Start IP: Enter start IP address of the IP-range.
End IP: Enter end IP address of the IP-range.

IP-range Table
Select: Select the desired entry for configuration.
Index: Displays index of the IP-range which is not configurable.
Start IP: Displays the start IP address of the IP-range.
End IP: Displays the end IP address of the IP-range.
9.2.7 Profile Binding
When the switch receives MLD report message, it examines the profile ID bound to the access
port to determine if the port can join the multicast group. If the multicast IP is not filtered, the switch
will add the port to the forward port list of the multicast group. Otherwise, the switch will drop the
MLD report message. In that way, you can control the multicast groups that users can access.