TP-Link T1700G-28TQ - VLAN Config

139
9.2.3 VLAN Config
On this page you can configure MLD snooping function with each single VLAN. You need to create
VLAN if you want to enable MLD snooping function in this VLAN.
Choose the menu Multicast→MLD Snooping→VLAN Config to load the following page.
Figure 9-15 VLAN Config
The following entries are displayed on this screen:

VLAN Config
VLAN ID: Enter the VLAN ID you want to configure.
Router Port Time:
Specify the aging time of the router port. Within this time, if the
switch don't receive MLD query message from the router port, it
will consider this port is not a router port any more.
By default, it
is 0 and the global router-time will be used.
Member Port Time:
Specify the aging time of the member port. Within this time, if the
switch don't receive MLD report message from the member port,
it will consider this port is not a member port any more.
By
default, it is 0 and the global member-time will be used.
Router Ports:
Specify the static router port which is mainly used in the network
with stable topology.

VLAN Table
Select: Select the VLAN ID you want to change.
VLAN ID: Displays the VLAN ID.
Router Port Time: Displays the router port time of this VLAN.
Member Port Time: Displays the member port time of this VLAN.
Static Router Ports: Displays the static router ports of this VLAN.
Dynamic Router
Ports
：
Displays the dynamic router ports of this VLAN.