TP-Link T1700G-28TQ - Page 67

57
Mode: Displays the mirror mode. The value will be "Ingress Only"
,
"Egress Only" or “Both”.
Source: Displays the mirrored ports.
Operation: You can configure the mirror session by clicking Edit
, or clear the
mirror session configuration by clicking the Clear.
Click Edit to display the following figure.
Figure 6-3 Port Mirror Config
The following entries are displayed on this screen:

Destination Port
Destination Port:
Input or select a physical port from the port panel as the mirroring
port.

Source Port
UNIT/LAGS: Click unit number to configure the physical ports
of this unit
member. Click LAGS to configure the link aggregation groups.
Select: Select the desired port as a mirrored port. It is multi-optional.
Port: Displays the port number.