User Guide 428
Configuring Routing Example for Static Routing
Switch_A#configure
Switch_A(config)#ip route 10.1.2.0 255.255.255.0 10.1.10.2
Switch_A(config)#end
Switch_A#copy running-config startup-config
Verify the Configurations
■ Switch A
Verify the static routing configuration:
Switch_A#show ip route
Codes: C - connected, S - static
* - candidate default
C 10.1.1.0/24 is directly connected, Vlan10
C 10.1.10.0/24 is directly connected, Vlan20
S 10.1.2.0/24 [1/0] via 10.1.10.2, Vlan20
■ Switch B
Verify the static routing configuration:
Switch_B#show ip route
Codes: C - connected, S - static
* - candidate default
C 10.1.2.0/24 is directly connected, Vlan30
C 10.1.10.0/24 is directly connected, Vlan20
S 10.1.1.0/24 [1/0] via 10.1.10.1, Vlan20
■ Connectivity Between Switch A and Switch B
Run the ping command on switch A to verify the connectivity:
Switch_A#ping 10.1.2.1
Pinging 10.1.2.1 with 64 bytes of data :
Reply from 10.1.2.1 : bytes=64 time<16ms TTL=64
Reply from 10.1.2.1 : bytes=64 time<16ms TTL=64
Reply from 10.1.2.1 : bytes=64 time<16ms TTL=64
Reply from 10.1.2.1 : bytes=64 time<16ms TTL=64
To Next Page
Loading...
