User Guide 508
Configuring ARP ARP Configurations
Step 1 configure
Enter global configuration mode.
Step 2 arp timeout
timeout
Configure the ARP aging time of the VLAN interface or routed port .
timeout:
Specify the value of aging time, which ranges from 1 to 3000 in seconds. The default
value is 1200 seconds.
Step 3 end
Return to privileged EXEC mode.
Step 4 copy running-config startup-config
Save the settings in the configuration file.
This example shows how to configure the aging time of dynamic ARP entries as 1000
seconds:
Switch#configure
Switch(config)#arp timeout 1000
Switch(config)#end
Switch#copy running-config startup-config
■ Clearing Dynamic Entries
Step 1 configure
Enter global configuration mode.
Step 2 clear arp-cache
Clear all the dynamic ARP entries.
Step 3 copy running-config startup-config
Save the settings in the configuration file.
■ Renewing Dynamic ARP Entries Automatically
Step 1 configure
Enter global configuration mode.
Step 2 arp dunamicrenew
Enable the switch to automatically renew dynamic ARP entries. By default, it is enabled..
Step 3 copy running-config startup-config
Save the settings in the configuration file.
To Next Page
Loading...
