Configuring ACL ACL Configuration
User Guide 671
D-MAC/Mask Enter the destination MAC address with a mask. A value of 1 in the mask indicates
that the corresponding bit in the address will be matched.
VLAN ID Enter the ID number of the VLAN with which packets will match. The valid range
is 1-4094. If the ACL is bound to a VLAN, the system requires the VLAN ID of a
packet to match the ID of the VLAN instead of the ID listed here.
EtherType Specify the EtherType to be matched using 4 hexadecimal numbers.
User Priority Specify the User Priority to be matched.
Time Range Select a time range during which the rule will take effect. The default value is No
Limit, which means the rule is always in effect. The Time Range referenced here
can be created on the SYSTEM > Time Range page.
Logging Enable Logging function for the ACL rule. Then the times that the rule is matched
will be logged every 5 minutes and a related trap will be generated. You can refer
to Total Matched Counter in the ACL Rules Table to view the matching times.
2) In the Policy section, enable or disable the Mirroring feature for the matched packets.
With this option enabled, choose a destination port to which the packets will be
mirrored.
Figure 2-5 Configuring Mirroring
3) In the Policy section, enable or disable the Redirect feature for the matched packets.
With this option enabled, choose a destination port to which the packets will be
redirected.
Figure 2-6 Configuring Redirect
To Next Page
Loading...
