User Guide 900
Configuration ExampleConfiguring SNMP & RMON
Figure 6-7 Enabling Storm Control Trap
7) Click to save the settings.
■ Configuring RMON
1) Choose MAINTENANCE > SNMP > RMON > Statistics and click
to load the
following page. Create Statistics entries 1 and 2, and bind them to ports 1/0/1 and
1/0/2, respectively. Set the owner of the entries as monitor and the status as Valid.
Figure 6-8 Configuring Statistics Entry 1
Figure 6-9 Configuring Statistics Entry 2
2) Choose the menu MAINTENANCE > SNMP > RMON > History to load the following
page. Configure entries 1 and 2. Bind entries 1 and 2 to ports 1/0/1 and 1/0/2,
respectively. Set the Interval as 100 seconds, Maximum Buckets as 50, the owner of the
entries as monitor, and the status as enabled.
To Next Page
Loading...
