TR-Electronic CE-65 - Adjust Absolute Value and Presets

Parameterization and configuration
 TR-Electronic GmbH 2007, All Rights Reserved Printed in the Federal Republic of Germany
Page 62 of 68 TR - ECE - BA - DGB - 0065 - 03 03/11/2016
7.3.4 Adjust Absolute Value
Risk of injury and damage to property by an actual value jump when the
Preset adjustment function is performed!
 The preset adjustment function should only be performed when the
measuring system is at rest, otherwise the resulting actual value jump must
be permitted in the program and application!
Instance 20, r/w
With the adjustment function, the measuring system is set to the desired absolute
position value.
Is the adjustment performed via the "Parameter Class", the required position value is
set with the "SET-service" and can read as position value with the "GET-service".
After adjustment, no DATA-CHECK is necessary.
0  Adjustment < Total Number of Steps