Resets temporary data:
•
•
This data should be reset to zero at the completion of a ride so that
new information can be logged on the next ride.
Notes:
•
•
Vector must be reset in order to recognize sensors:
•
•
33
Normal Mode
Reset Single-Ride Data to Zero:
TO RESET SINGLE RIDE DATA,
HOLD THE LEFT AND CENTER
BUTTONS FOR 3 SECONDS.
The reset can be done from any screen.
Accumulated Ride Time (ART) and Odometer (ODO) cannot be
reset and are intended to maintain cumulative information.
Maximum Speed (MS)
Stop Watch (TT)
If any wires become unplugged from Vector, do a data reset after
everything is properly re-connected.
Alternatively, push the red reset button on the back of Vector.
Maximum Speed (MS)
Stop Watch (TT)
•
•
To Next Page
Loading...