Trane UniTrane Fan-Coil - Displaying Setpoint or Temperature

Installation - Zone Sensors
UNT-SVX07E-EN 71
Displaying Setpoint or Temperature
You can configure the sensor to display either the
temperature (default) or setpoint. To select either option:
1. Verify that the sensor is in operating mode and at the
home screen.
2. Press the up and down arrows for 3 seconds. The arrow
indicates setpoint display, as shown in Figure 62.
Table 25. Configuration options for wireless display sensors
Setting Configuration Options
Temperature
• Choose Fahrenheit or Celsius
• Choose the degree resolution
(whole degrees, half degrees, or
tenths of degrees).
Setpoint
System
Fan
Note: Not all fan options are available
for all systems.
Occupancy (timed override)
. .
.
.
.
.
No
setpoint
Single
setpoint
No system
options enabled
Auto/Off/Low
Med/High
Auto/Off/
Low/High
Auto/Off
Off/High (On)
Off/Low/High Off/Low/
Med/High
No fan options
enabled
Occupancy
enabled
Occupancy
disabled
Figure 62. Displaying setpoint or temperature
Temperature Setpoint
Arrow indicates
setpoint display