ECM Overview and Setup
90 UNT-SVX07E-EN
Configuration Examples
Example 1.
To view the value of parameters without
saving. In this case we wish to verify that the “Low Speed
Value” for Motor 1 is set correctly to 800 rpm.
We start with the motor control board scrolling status
display and proceed as follows:
Example 2.
We wish to change the change the value of
Low Speed to 820 rpm:
We will continue from the previous example as shown
below, using a long press to “save” the new desired value.
Note: If the display has timed out and returned to the
status loop, repeat Example 1 to arrive back at this
example’s starting point.
Table 39. Button actuation levels
Button
Menu/Set
Duration Action
Short Press in
Status Display
<1 sec None
Short Press in Configuration Display Toggles between parameter name and value without saving
(abandons value if changed).
Long Press/Hold
in Status Display
>3 sec Enters the configuration menu
Long Press/Hold
in Configuration Display
>3 sec If on a parameter name, toggles to the value. If on a parameter value,
saves the value settings and returns to the parameter name as
confirmation.
Button
Decrement
Duration Action
Short Press in
Status Display
<1 sec None
Short Press in Configuration Display <1 sec Scrolls through parameter names, or decreases value of parameter.
Long Press/Hold
in Status Display
>3 sec n/a
Long Press/Hold
in Configuration Display
>3 sec Faster scroll through parameter name, or faster decrease of values of
parameters.
Button
Increment
Duration Action
Short Press in
Status Display
<1 sec None
Short Press in Configuration Display <1 sec Scrolls through parameter names, or increases value of parameter.
Long Press/Hold
in Status Display
>3 sec n/a
Long Press/Hold
in Configuration Display
Faster scroll through parameter name, or faster increase of values of
parameters.
Figure 80. Verify low speed value
Figure 81. Change value of low speed
To Next Page
Loading...
Need help?
General
