33
The following values are reported at the end of a measurement:
Wet Density is the total mass of material per unit volume in pcf or kg/m³
Volumetric Moisture is the mass of water per unit volume in pcf or kg/m³, measured by the SDG.
% Moisture = water content as percent of dry density =
Dry Density = Wet Density – Volumetric Moisture
% Compaction = Dry Density
Max Dry Density
The chart below provides guidance to a few suspect conditions.
Troubleshooting
Problem
Remedy
Battery Problems/Gauge Keeps Shutting
Down/Gauge Will Not Come On
Ensure battery pack is plugged in
Check battery voltage-plug gauge into charger and
wait for the green LED to illuminate to indicate a full
charge
Call Factory
Data is not recording Check Current Project Name-data readings will
store on the Current Project only, be sure you have
the correct Project name set on the gauge (Verify the
name of the Project and Mix on each reading screen)
GPS Communication Errors
Call Factory
Part 5: Definitions and Calculations
Measurement Results
To Next Page
Loading...
