Transtech SDG 200 User Manual

Soil Density Gauge
Operator’s Handbook

Transtech SDG 200 Specifications

General

Data Storage	Internal memory
Display	LCD
Resolution	1mm
Power Supply	Rechargeable battery
Accuracy	±(2mm + 2ppm)
Temperature Compensation	Automatic

Summary

Introduction to the Soil Density Gauge

Measurement Technology

Explains the electrical impedance spectroscopy (EIS) measurement principle.

Safety Precautions

Provides essential safety precautions and warnings for using the gauge.

Controls & Components Overview

Package Contents

Gauge Features Identification

Identifies and explains the various external features of the SDG 200 unit.

External and Internal Controls

Details the ON/OFF switch and touchscreen interface for navigation.

Setting up the SDG 200

Installing and Charging the Batteries

Provides step-by-step instructions for battery installation and charging.

Starting the Software

Guides the user on powering on the SDG 200 and navigating to the Main Menu.

Setup the GPS Module

Control Menu Navigation

Project Details Management

Editing Project Details

Guides the user through editing project information using the on-screen keyboard.

Material Properties Management

Defining and Editing a Material

Explains how to select and modify material properties for the current test.

Setting Measurement Offsets

Explains the purpose and use of measurement offsets for accuracy.

Determining Offset Values

Describes methods for determining appropriate measurement offsets.

Uploading a Material Definition

Running a Test Procedure

Surface Preparation Guidelines

Measure Density Process

Guides on initiating and performing density measurement tests.

Data Storage and Downloading

Downloading Data Files

Maintenance and Troubleshooting

Routine Maintenance

Troubleshooting Common Issues

Provides solutions for common problems encountered with the SDG 200.

Standardization of the SDG

Gradation and Compaction Reports

Explanation of Gradation and Compaction Reports