Even when the battery gauge shows ‘empty’, there is still enough energy remaining to run the lights
for about two hours. If the battery pack is fully drained, the lights will be powered by the system as
it switches to generative mode automatically.
• Removing and installing the Controller
The ‘RIDE+ Easy’ Controller can easily be removed from the bike: just slide it to the right. Putting
the Easy controller onto the bike is just as easy: slide it from right to left into its clamp until it clicks
in place.
• Unintended removal of Controller out of its dock
If the controller is moved off its clamp while the system is active (‘On’), the system will no longer
assist, even when the controller is replaced into its clamp. Please select the correct level of
assistance again to reactivate the system.
To Next Page
Loading...
