Trek Ride Plus - Programming (Bikes with Bionx G2 and RIDE+ Pro Controller Only)

33
ENGLISH
Range for a fully charged battery pack (‘RIDE+ R320’ and ‘RIDE+ C320’; 320 Wh)
Terrain/Assistance level 1 (25%) 2 (50%) 3 (100%) 4 (200%)
Flat terrrain
55-90km 50-70km 45-55km 30-40 km
Hilly terrrain
45-75km 35-60km 30-45km 20-30 km
Mountainous terrrain
30-45km 30-45km 20-30 km 15-25km
Range for a fully charged battery pack (‘RIDE+ C420’; 420 Wh)
Terrain/Assistance level 1 (25%) 2 (50%) 3 (100%) 4 (200%)
Flat terrrain
80-125km 60-100 km 55-80km 40-55km
Hilly terrrain
65-100km 45-85km 35-65km 25-40km
Mountainous terrrain
45-65km 35-60km 25-40km 20-35km
• Transporting an electric bike on a vehicle
Because an electric bike is heavier than a normal bicycle due to the additional drive components,
take care of the following when transporting the electrical bike on a vehicle:
a. Take care about the maximum pressure on the towbar of the vehicle when placing a bike carrier
onitwithmultiplebicycles,includingane-bike.Pleaserefertothemanualofthetowbarand/or
the vehicle for additional information.
b.. Take care about the maximum load capacity of the car’s roof when placing a bike carrier on it
withmultiplebicycles,includingane-bike.Pleaserefertothemanualofthevehicleand/orbike
carrier for additional information.
c. A bike carrier has a limited load capacity. Sometimes that is not enough to carry an (heavier)
electrical bicycle in combination with other (e.g. electrical) bicycles. Please refer to the manual of
the bicycle carrier for more detailed information.
d. Remove the battery pack and, if present, panniers of the electrical bicycle and store it elsewhere
in the vehicle during the drive.
e. Always respect local laws about transportation of a(n electric) bicycle.
Warning. The drivability of the vehicle may change with extra weight on (the back of) the vehicle.
4.10 Programming (bikes with ‘BionX G2’ and ‘RIDE+ Pro’ controller only)
This section explains how you set the odometer units (miles or kilometers), the clock, the wheel
diameter and how you can swap the functionality of the buttons and select the correct language.
Toenterprogrammingmode,pressbuttons‘On/Off’and‘Mode-switch’fortwoseconds.
instruCtions For use