Trek Ride Plus - RIDE+ Easy II Controller Operations

1
7
8
2
3
56
4
26
ENGLISH
4.4 RIDE+ Easy II Controller
1•Levelindicator2•Sidebutton(On/Off,LightOn/Off)3•Lightindicator,OnorOff4•Battery
chargelevel5•Front+(righthand)button,Miles/Kilometersswitchbutton6•Front-(lefthand)
button,Modeswitchbutton7•Distance,Odometer8•Speedindication
• Switching system On/Off
To switch the system On, push the ‘Side’ button once shortly.
The battery pack will emit four short ‘beeps’ and the system will do a
self-check. To switch the system Off, press the ‘Side’ button again.
The battery pack will emit five short ‘beeps’. There is no difference
between riding with the system ‘on’ in level ‘0’ or ‘Off’. If the bike is left
with the system on, it will automatically switch off after about 10
minutes.
• Assistance/(Regeneration) Level
There are four levels of assistance. The arrows in the right top corner of
the display show in which assist-level the system is. For pedaling-
assistance, press the ‘+ (right hand)’ button. For assistance level 1, press
once. Press again for more assistance. Push the ‘- (left hand)’ button to
go to a lower level. When arrows in the right top corner are all outlined
only, you are pedaling a normal bicycle. When the rear brake is pulled,
the system switches to generating and two arrows on the display will start blinking.
Regeneration levels are not installed as standard on the controller. This means that the motor will
only generate energy when the rear brake is pulled. However, if you want to, your dealer can
activate the regeneration levels. Regeneration levels can be controlled in a similar way if no level
is activated on the controller. Push the ‘-’ button once for regeneration level 1, again for higher
levels. Push the ‘+’ button to go to a lower level.
Notice. It is strongly advised to ride away in a straight line when an assistance level is selected.
Never select assistance level 3 or 4 during maneuvering or riding away in a tight corner. The powerful
reaction of motor might take you unawares.
• Switching lights On/Off
Pressthe‘Side’buttonfor2secondstoswitchOn/OfftheController
display light, and if present, the front and rear lights. Once activated,
the light symbol will appear on the screen. The lights will stay on
even when you stop. Even when the battery gauge shows ‘empty’, there
instruCtions For use