Trek Ride Plus - Quick Start - RIDE+ Pro Controller

riDe+ Pro Controller - QuiCk start
7
ENGLISH
1.2 RIDE+ Pro Controller
• Switching system On/Off
Push any of the two upper buttons shortly to switch the
system ‘On’. Push the button to switch the system off.
When switched on, the bike is in cycle mode (zero assist).
• Assistance/Regeneration Level
Push the ‘+’ button once for assistance level 1, again
for higher levels. Push the ‘-’ button to go to a lower
level. Regeneration levels can be controlled in a similar
way. Push the ‘-’ button once for regeneration level 1,
again for a higher level. Push the ‘+’ button to reduce
regeneration.
Notice. It is strongly advised to ride away in a straight line when an assistance level is selected.
Never select assistance level 3 or 4 during maneuvering or riding away in a tight corner. The powerful
reaction of motor might take you unawares.
• Switching lights On/Off
Press the buttonfor2secondstoswitchOn/Offthe
Controller display light, and, if present, the front and rear
lights. Once activated, the text ‘Light On’ or ‘Light Off’
will appear in the lower field of the display.
• See time, average speed, odometer, trip distance
Use button to change bike computer functions
(Order of appearance: trip distance, odometer, average
speed, time). To prevent loss of riding information,
please make sure that the system is switched off
before the controller is removed from the bike.
• Using the RIDE+ Link
Most bikes with the ‘RIDE+ Pro’ controller positioned on the middle clamp are
equipped (or can be equipped) with the RIDE+ Link. This device can be used to
selectahigherorlowerassistorregenerationlevelandtoturnthelightsOn/Off
without removing your hands off the handlebars.The red throttle button on the
RIDE+Linkisaconvenienthelptomovethebikewithoutpedaling(upto4km/h)
walking next to the e-bike.
Caution. Beware of unintended use of the throttle button when the system is switched on.