1. Quick start
This manual has all the information that you’ll
need to get the best from your electric bicycle.
We strongly recommend that you read it through.
However, for quick use of the bike, please read
the Quick Start guide for the type of controller
and battery pack on your bicycle.
1.1 BionX G2 Controller
• Switching system On/Off
Push any of the two upper buttons shortly to switch the
system ‘On’. Push the button to switch the system off.
When switched on, the bike is in cycle mode (zero assist).
• Assistance/Regeneration Level
Push the ‘+’ button once for assistance level 1, again
for higher levels. Push the ‘-’ button to go to a lower
level. Regeneration levels can be controlled in a similar
way. Push the ‘-’ button once for regeneration level 1,
again for a higher level. Push the ‘+’ button to reduce
regeneration.
Notice. It is strongly advised to ride away in a straight line when an assistance level is selected.
Never select assistance level 3 or 4 during maneuvering or riding away in a tight corner. The powerful
reaction of motor might take you unawares.
• Switching lights On/Off
Press the buttonfor2secondstoswitchOn/Offthe
display light, and, if present, the front and rear lights.
• See time, average speed, odometer, trip distance
Use the button to change ccomputer
functions (Order of appearance: trip distance,
odometer, average speed, time of day). To prevent loss
of riding information, please make sure that the
system is switched off before the controller is removed
from the bike.
• Using the remote
Some bikes have the controller positioned on a middle clamp, which means that
the controller can more easily be operated with a remote. This device can be used
to select a higher or lower assist or regeneration level without removing your hands
off the handlebars. The red throttle button on the BionX remote is a convenient
helptomovethebikewithoutpedaling(upto4km/h)walkingnexttothee-bike.
Caution. Beware of unintended use of the throttle button when the system is switched on.
To Next Page
Loading...
