TRENDnet TEW-735AP User Manual

TRENDnet User’s Guide TEW-735AP
© Copyright 2015 TRENDnet. All Rights Reserved. 21
DHCP Server
The TEW-735AP is equipped with a DHCP server to assign IPv4 addresses
dynamically. The assigning IP address range must be in the subnet that
was used in IP Settings. By default, the DHCP server is disabled. If you
want to enable it, select Enabled from the DHCP Server drop down list.
Enter the requested information and click Apply to save the change and
activate DHCP server.
DHCP Server
DHCP Server :
Choose Enabled or Disabled from the drop
down list.
Lease Time :
How long the assigning IP will be valid.
Start IP :
Starting IP address of DHCP pool.
End IP :
Last IP address of DHCP pool.
First DNS
Address :
Primary DNS server address you want to
assign with DHCP lease.
Second DNS
Address :
Secondary DNS server address you want to
assign with DHCP lease.
Spanning Tree
The TEW-735AP is designed for end point access as well as backbone
connection. To avoid network looping, you can enable 802.1d Spanning
Tree Protocol (STP).
Spanning Tree
Spanning Tree
Status:
Enable or disable 802.1d spanning tree
protocol to avoid network looping.
Bridge Hello
Time:
The time between each bridge protocol
data unit (BPDU). Default: 2 sec.
Bridge Max Age:
Maximum time a BPDU kept in bridge.
Default: 20 sec
Bridge Forward
Delay:
The time spent in listen and learning state.
Default: 15 sec.
Bridge Priority:
Priority number for root bridge selection.
(MAC number is listed on Status > Main
page)
Apply: Click this button to save and activate
Cancel: Click this button to abandon the change

TRENDnet TEW-735AP Specifications

General

Modulation	-
Frequency band	2.4 GHz
Number of users	- user(s)
Channels quantity	- channels
Networking standards	IEEE 802.11az, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3af, IEEE 802.3u, IEEE 802.3x
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	No
Certification	CE, FCC
WAN connection	Ethernet (RJ-45)
Security algorithms	WPA2
Operating temperature (T-T)	0 - 45 °C
Power supply	12 W
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Cables included	LAN (RJ-45)
Antenna features	Integrated antenna
Antennas quantity	2
Antenna gain level (max)	4 dBi

Weight and Dimensions

Depth	60 mm
Width	128 mm
Weight	210 g