INTRODUCTION / SYSTEM OVERVIEW Page 4 / 77
SYSTEM OVERVIEW
LiveLink contains only one hardware component, the LiveLink control
device. Luminaires, sensors, push-buttons and/or push-button cou-
plers are connected to the LiveLink control device via DALI.
In addition, LiveLink includes two software components: The “Live-
Link Install” tablet app for the setup of the system by expert person-
nel, and the “LiveLink Control” tablet and/or smart phone app for the
control of the illumination by the end user.
The tablet and/or smart phone communicate directly with the control
device which is equipped with a WLAN of its own (access point) for this
purpose. But, as an alternative, the LiveLink control device can also
be integrated into the network structure of the building.
The controlling of the lighting can be performed in two ways:
1. The activating of light scenes or switching and dimming of lumi-
naire groups can be carried out with commercial push-buttons via
the DALI installation.
In addition, a push-button can be connected directly to the LiveLink
control device.
2. Control via the “LiveLink Control” app. The app provides for access
to all light scenes and individual control of luminaire groups.
Sensor
Control gear
Direct connection for 1 push-button
Option
Connection to a building network structure
Push-button coupler
To Next Page
Loading...
Need help?
General