“LIVELINK INSTALL” APP / ROOM ADMINISTRATION / SETTINGS: UPDATE FIRMWARE Page 64 / 77
SETTINGS: UPDATE FIRMWARE
Tapping on “Update firmware” starts the update
process of the operating software of the LiveLink
control device.
The most current firmware is transferred from the
app to the control device via WLAN and installed on
it. For this, no Internet connection is necessary.
Caution: The firmware is stored in the “LiveLink
Install” app. To ensure that the most current firm-
ware is being utilised, the app should be updated
in advance. (Typical update process via the Apple
App Store on iOS devices or the Google Play Store
on Android devices; Internet connection required)
A window shows which version is currently installed
and to which version an update can be performed.
Upon confirmation, the firmware is uploaded to
and subsequently installed on the control device
(”LiveLink flashing”).
A window indicates the completion of the update.
The system restarts. The app then displays the
room selection view again
To Next Page
Loading...
Need help?
General