“LIVELINK INSTALL” APP / ROOM ADMINISTRATION / SETTINGS: DALI FADE TIME Page 61 / 77
SETTINGS: DALI FADE TIME
The DALI fade time controls the transition time
between the dimming levels. In case of a setting of
“0 s”, the brightness is changed without dimming
function. The longer the transition time, the softer
the dimming process appears to be.
To change the DALI fade time, the desired time is
selected by swiping vertically and subsequently
stored by tapping on “Accept DALI fade time”.
SETTINGS: RESET LIVELINK AND HARDWARE RESET
After tapping “Reset LiveLink” and subsequent
confirmation, the LiveLink control device is reset to
delivery condition.
Caution: All settings will be deleted!
For a hardware reset, the DALI connections are
short-circuited (connecting both DALI lines) and at
the same time the internal push-button on the control
device is held down for 20 seconds. For this, a
push-button should be connected to the designated
interfaced (S) of the LiveLink system.
To Next Page
Loading...
Need help?
General