Need help?Do you have a question about the Trilux LiveLink and is the answer not in the manual?
General| Type | Control Unit |
|---|---|
| Input Voltage | 230V AC |
| Frequency | 50/60 Hz |
| Protection Rating | IP20 |
| Communication Protocols | DALI |
| Mounting Options | DIN rail |
Details the core functionalities of the LiveLink light control system for optimal illumination.
Essential safety precautions for working with electrical devices and system installation.
Instructions for downloading the 'LiveLink Install' and 'LiveLink Control' apps.
Describes the LiveLink control device and its associated software applications.
Explains the two primary ways to control lighting: push-buttons and the LiveLink Control app.
Details the controller's compact design, DALI interface, and control capabilities.
Explains the autarkic WLAN encryption for protection against external access.
Lists environmental factors and devices to avoid near sensors for accurate detection.
Step-by-step guide to connecting an iOS device to the LiveLink WLAN.
Instructions for connecting an Android device to the LiveLink WLAN.
Explains how light control behavior varies based on activation modes like presence detection.
Details automatic and semi-automatic presence detection and constant light control.
Explains how manual changes affect constant light control and dimming levels.
Describes manual switching, dimming, and turning off of luminaire groups.
Defines a Use Case as a pre-configuration simplifying room setup with specific scenarios.
Lists available public Use Cases categorized by building application areas.
Steps to guide through the initial setup of a new room.
Allows connecting the control device to an existing network infrastructure.
Connects the tablet directly to the LiveLink control device's WLAN for setup.
Guide on starting the 'LiveLink' app on iOS or Android for configuration.
Selects the room in the administrator menu; initial designation is a factory setting.
Procedure to set a new administrator password for secure system access.
Initiates the room creation process, leading to the 'Select Use Case' step.
Explains how to identify connected devices using icons and visual feedback.
Allows selecting a Use Case via swiping and confirming the choice.
Choosing between public or private Use Case collections for room setup.
Selects a Use Case by swiping through options, using schematics for guidance.
Confirms the chosen Use Case by tapping, completing this setup step.
Assigns identified luminaires to predefined luminaire groups using drag and drop.
Assigns available sensors to specific sensor locations within the room schematic.
Assigns selected luminaires to a group; one assignment applies to the entire selection.
Assigns sensors analogously to luminaires, using control lamp for identification.
Tests detected movements and allows adjustment of detection range for sensors.
Connects push-buttons to light scenes or luminaire groups for activation.
Explains how to create new push-button assignments by tapping the plus symbol.
Selects whether a push-button activates a scene or controls a luminaire group.
Starts the process of creating a new push-button assignment.
Signals LiveLink waiting for push-button assignment; requires pushing and holding the button.
Sets a user password for light control access via the 'LiveLink Control' app.
Details creating new scenes from scratch or duplicating existing ones.
Explains configuring sensor options for presence detection and constant light control.
Sets the desired dimming level for activated luminaire groups using the control wheel.
Allows changing administrator and user passwords.
To Next Page
