Trilux LiveLink User Manual

INTRODUCTION / BEHAVIOUR OF LIGHT CONTROL / BEHAVIOUR IN DELIVERY CONDITION
Szene
i
Page 15 / 77
Scene
i
If the default scene contains presence detec- tion with fully automatic operation, the lighting starts with the default scene upon entering the room. If the scene additionally contains constant light control, the overall illumination (from daylight and artificial light) is continuously being ad- justed to the pre-set target value. If the default scene contains presence detec- tion with semi-automatic operation, the scene is started with a push-button or with a tablet and/or smart phone. If the scene additionally contains constant light control, the overall illumination (from daylight and artificial light) is continuously being ad- justed to the pre-set target value.
The illumination ad- justs itself to the changed daylight.
In case of a manual intervention, the dim- ming and switching of luminaire groups, the constant light control is deactivated for these luminaire groups. During the stay in the room, the changed dimming levels of the illumina- tion are retained.
CHANGE OF THE SCENE If a change is made to a scene that contains other operating modes (constant light control and presence detection), the behaviour does, of course, change as well (see other pages in this chapter).
In case of strong ingress of sunlight, the illu- mination initially dims to a minimum. If the overall illumination exceeds the target value by 25 % for more than 5 minutes, the illumi- nation turns off.
If the daylight be- comes less, the illumi- nation switches itself on again and adjusts to the target value.
Subsequent to a subsequent holding time, the illumination turns off after the room has been left.
The presence detection remains maintained even after a manual change of the illumi- nation. Subsequent to a subsequent holding time, it turns the illumination off after the room has been left.
• CONSTANT LIGHT CONTROL • PRESENCE DETECTION
(AUTOMATIC OPERATION)
• CONSTANT LIGHT CONTROL • PRESENCE DETECTION
(SEMI-AUTOMATIC OPERATION)
MANUAL CHANGES TO THE ILLUMINATION
ADVANCED SETTINGS Through advanced settings in the default scene, a switching on again of the illumina- tion upon dropping below the target value can be prevented.

Trilux LiveLink Specifications

General

Type	Control Unit
Input Voltage	230V AC
Frequency	50/60 Hz
Protection Rating	IP20
Communication Protocols	DALI
Mounting Options	DIN rail