“LIVELINK INSTALL” APP / ROOM ADMINISTRATION / ROOM SETUP: OPTION “SETTING UP SCENES” Page 56 / 77
Presence detection: IQ mode
If the switch-off delay is set to “0” with the control
wheel, the IQ mode is activated.
The IQ mode analyses the utilisation of the room
based on the detected movements.
In IQ mode, the delay period is between 5 and 20
minutes long.
If a lot of movements are registered, the delay period
doubles, if hardly any movements are registered,
the delay period is cut in half.
In case of constant utilisation of the room, this does,
for example, result in the illumination not being
shut off directly when somebody leaves the room
or if somebody is not moving for a while. But if the
room is used only sporadically, the delay period is
automatically reduced to 5 minutes.
Presence detection: Fully automatic
The illumination is switched on and off automatically,
depending on brightness and presence detection.
Presence detection: Semi-automatic
The illumination is only switched off automatically
in this case. The switching on is performed manually.
To Next Page
Loading...
Need help?
General