“LIVELINK INSTALL” APP / ROOM ADMINISTRATION / ROOM SETUP: OPTION “SETTING UP SCENES” Page 55 / 77
Configuring a sensor
By tapping a sensor, the sensor functions are offered.
Depending on the sensor utilised, a presence
detection and/or a constant light control can be
configured.
Subsequent to the selection of a function, the luminaire
groups linked with this function are provided with
a red background. The assignment of the sensor
controls to the luminaire groups takes place in the
luminaire assignment (see chapter “Room setup:
Assignment”).
Setting up the presence detection
Tapping on the sensor symbol (at the control wheel)
activates and/or deactivates the sensor.
The switch-off delay is set with the control wheel.
To Next Page
