REAR SUSPENSION 11
5.
Position the spacers on either side of the rear
DROP LINK
suspension unit lower mounting with their smaller
outside diameters towards the mounting.
Removal
gagk
1. Rear suspension unit
2.
`O' rings
3.
Spacers
6.
Pivot the drag link and drop link into position and
loosely fit the securing bolt / nut.
7.
With the weight of the motorcycle on its wheels,
tighten the rear suspension unit upper mounting to
48 Nm.
8.
Tighten the rear suspension unit lower mounting to
100 Nm.
9.
Connect the battery, red (positive) lead first.
10.
Fit the rear body panels and the seat.
WARNING: If the engine has recently
been running, the exhaust system will be
hot. Before working on or near the exhaust system,
allow sufficient time for the exhaust system to cool
as touching any part of a hot exhaust system could
cause burn injuries.
WARNING: Ensure the motorcycle is
stabilised and adequately supported, to
1.
Raise and support the rear of the motorcycle under
the frame or engine. Position a block to support the
rear wheel.
1. Rear suspension unit
2. Drop link
3. Drag link
2.
Remove the nut and bolt securing the the drop link
and drag link to the rear suspension unit lower
mounting. Pivot the links clear and capture the 2
spacers and their 'O' rings on either side of the rear
suspension unit mounting.
3.
Remove the bolt securing the drop link to the
swinging arm.
11.7
To Next Page
Loading...
