50
Chapter 7: Plumbing Walkaround Models • Owner’s Manual Supplement
• Before using this system, read the marine head operation and maintenance manual.
• The holding tank is plumbed to a waste fitting on the deck for dockside pump-out.
• Look at the side of the holding tank to check the content level.
• Empty the holding tank at every opportunity.
Using The Marine Head
1. Open the head’s seawater pickup seacock.
2. Before using the head, pump water into the bowl to wet the sides.
3. After use, pump until the bowl is clean.
4. Pump a few more times to clean the lines.
5. If excess waste causes the water to rise in the bowl, stop pumping until the water recedes.
Winterizing The Marine Head
1. Shut Off the intake seacock and pump the head until the bowl is dry.
2. Remove the drain plug in the base and pump again to remove all of the water.
• Do not fill the bowl with anti-freeze.
• Close the intake seacock while the boat is underway or whenever the boat is left moored in the water.
To use the macerator to pump waste directly into the water (where regulations permit):
1. Open the underwater discharge seacock.
2. Press both macerator switches at the same time to run the pump. Do not continue running the macerator if the
waste holding tank is empty.
3. Close the underwater discharge seacock when you are done pumping.
Check with local authorities for regulations regarding the legal use of marine head systems.
NOTICE
To Next Page
Loading...
