Safety
•
Operate the machine described here only with a lens in place. A missing lens may cause the unfocused laser beam
to be reflected out of the housing.
•
Stop this machine immediately in case of failure.
•
No working methods are permitted that affect the safety of persons or of the machine.
•
The machine and its components, such as the lens and mirrors, are to be kept clean at all times.
Caution
The adjustment of the beam path may only be carried out by service personnel of Trotec Laser GmbH.
2.4 Requirements for operating an service personnel
The requirements for the operating and service personnel are:
•
The personnel must have read and understood this manual and in particular the "Safety" section.
•
The personnel must not be under the influence of drugs, alcohol or reactivity affecting medication when working on
or with the machine.
•
The personnel must be familiar with using the CO
2
fire extinguisher.
•
The personnel must be trained in order to be qualified to operate the machine. If the personnel lack the necessary
knowledge for working on or with the machine, they must first be trained and note down the training in the training
verification form.
Activity Intended user group Definition
Control/operation/other activities
(e.g. troubleshooting, maintenance)
Qualified personnel or
Trotec service technicians
Qualified personnel are those who can judge the
work entrusted to them and detect potential risks
based on their occupational training, knowledge
and experience as well as their understanding of
the relevant regulations.
2.5 Machine identification (warning and safety stickers)
The warning and information signs are attached to the device at those places which could be a source of danger before
commissioning or during operation. Therefore pay special attention to the information on the signs.
Caution
Lost or damaged warning and safety stickers.
If any warning and safety stickers are lost or damaged, the user is not able identify risks anymore, and
there is danger of injury.
– Replace lost or damaged labels immediately.
– Contact your Trotec Laser GmbH dealer for details.
18
To Next Page
Loading...
Need help?
General
