Operation
3. Press the two keys from the Working table control button Z (1)
simultaneously for the laser beam to get automatically focused on
the workpiece.
Focusing is then complete, and you can start the laser processing.
Notice
This focusing mode is especially well-suited for all sound-relective materials.
7.8.3 Soware focus
The following values mustbe entered in JobControl®:
•
Lens type
•
Material thickness (exact measurement)
•
Material process type
Caution
The values entered must match the material and the lens in the machine in order to avoid a head crash.
When using spacer the total material thickness is determined by the thickness of the spacer and the
material.
56
To Next Page
Loading...
Need help?
General
