Safety
•
Wear proper protective clothing (respiratory protection, protective goggles, protective suit, rubber or plastic gloves).
•
Provide ventilation.
•
When approaching the system again, pay attention to odors.
•
Remove all lens fragments.
•
Avoid raising or dispersing dust.
Disposal
The ZnSe dust and the lens are to be collected drily and disposed of with fragments, broom, shovel and
protective clothing into hermetically sealable containers or plastics bags as hazardous waste.
Do not dispose of optical components as domestic waste, and do not let them enter the sewer or
water bodies.
Dispose of according to regulations and laws valid in the users' country.
2.9 In case of emergency
WHAT TO DO IN THE EVENT OF MALFUNCTIONS
•
In unusual operating conditions, open the lid to stop the machining process press the emergency stop button and
switch off the machine.
•
If necessary, disconnect the machine from the main power supply.
•
Inform the laser protection officer and your supervisor.
•
Repair work must only be carried out by Trotec Laser GmbH service technicians.
•
In the event of a fire: Fight the fire with a CO
2
fire extinguisher as far as is possible without risk.
Notice
Aer a deletion, Trotec Technical Support must be involved before the system is put back into operation.
WHAT TO DO IN THE EVENT OF AN ACCIDENT, FIRST AID
•
If eye damage occurs due to laser radiation, the casualty must present to an ophthalmologist immediately.
•
First aiders must protect themselves.
•
Disconnect the device from the power supply and secure it against restarting
– Remove the key switch.
– Unplug the power cable.
•
Rescue the injured person from the danger area and provide first aid.
•
Call an emergency doctor!
25
To Next Page
Loading...
Need help?
General
