Transport
6. Remove the packing material.
7. The machine must be adjusted and installed by a
technician (see installation guide Q400).
5.7.1 Transport protection for the axes
Information
The illustrations used do not correspond to the original condition of the machine and are for information
purposes only.
Remove the transport protectors marked in the picture,
which fix the x-axis and y-axis. To do this, remove the two
screws in each case.
5.8 Relocation of the machine
STEPS:
1. Switch off the machine.
2. Disconnect the power cable.
3. Remove the exhaust system.
4. Reposition the machine (e.g. with auxiliary equipment if necessary) and place it on a level, clean floor.
5. Adjust the machine.
39