3. Open the printer’s top cover and separate the
media holders to fit the media width. Press down
the media holder lock switch to fix the media
holder.
4. Feeds the media through the rear external label
entrance chute. And place the paper, printing side
face up, through the media sensor and place the
label leading edge onto the platen roller. Move the
media guides to fit the label width by turning the
guide adjuster knob.
5. Disengage the top cover support and close the top
cover gently. Use software or LCD menu function to
set the media sensor type and calibrate the
selected sensor. (refer to chpter 4&5)
To Next Page
Loading...
