1. Open the printer top cover by
pressing the top cover open tabs
located on each side of the printer.
2. Insert the paper core to the ribbon
rewind spindle.
Note: Please follow the direction
when installing the ribbon rewind
spindle.
3. Insert the right side of ribbon rewind
spindle to ribbon rewind hub first.
Then, insert the left side to the hole
at the left side of ribbon mechanism.
Note:
It can also be substituted by 0.5 or
1 inch paper roll with notches on
both sides. Please insert it at the
ribbon rewind hub directly.
To Next Page
Loading...
