TTP-225/323
Bar Code Printer Service Manual
23
3.8Cutter Module Installation (Option)
1. Refer to section 3.2 to remove the lower cover.
2. Thread the cutter module 8-pin harness through the front slot of lower inner cover.
Connect the cutter module harness connector to the 8-pin white socket on the printer
main board.
3. Take off the interface plate from the lower cover.
4. Then, put back the lower inner cover. Place the cutter module into the both sides
notches of lower inner cover, then push cutter to lock into the lower inner cover.
To Next Page
Loading...
