Why the printing position of small label is incorrect on TSC TX200 Printer?
If the printing position of small labels is incorrect on your TSC printer, the media sensor sensitivity may not be set properly. Calibrate the sensor sensitivity again.
How to fix poor print quality on my TSC printer?
To improve the print quality of your TSC printer, try the following: * Reload the ribbon and media. * Clean the print head to remove any dust or adhesive. * Adjust the print density and print speed. * Run a self-test to check for damage to the print head element. * Ensure you are using compatible ribbon and label media.
How to resolve 'No Paper' error on my TSC printer?
If your TSC printer shows a 'No Paper' error, first ensure that you have a new label roll. If the roll is new, make sure the label roll is correctly installed. You might also need to calibrate the gap/black mark sensor.
Why is there no print on the label from my TSC printer?
If your TSC printer is producing blank labels, ensure that the label and ribbon are loaded correctly according to the instructions. Verify that the ribbon and media are compatible, paying attention to the ribbon-inked side. Also, consider cleaning the print head.
What to do if TSC printer takes label?
If your TSC printer is set to 'Take Label', and the peeler module is installed, remove the label.
Why is the RTC time incorrect when I reboot my TSC TX200 Printer?
If the RTC time is incorrect after rebooting your TSC printer, the battery may have run down. Check if there is a battery on the main board.
Why does the TSC TX200 Printer power indicator not illuminate?
If the power indicator on your TSC printer is not lit, ensure the power cord is correctly plugged into both the printer and the outlet. Also, make sure the printer is switched on.
What to do if my TSC printer shows 'Carriage Open'?
If the LED indicates that the carriage is open on your TSC printer, ensure that the print carriages are completely closed.
How to resolve gray line on blank label with my TSC Barcode Reader?
Gray lines appearing on blank labels from your TSC Barcode Reader can be due to: * A dirty print head. Clean the print head. * A dirty platen roller. Clean the platen roller.
What to do if my TSC Barcode Reader is continuously feeding labels?
If your TSC Barcode Reader is continuously feeding labels, it could be due to: * An incorrect printer setting. Initialize the printer and perform gap/black mark calibration. * Improper gap/black mark sensor sensitivity. Calibrate the gap/black mark sensor. * Incorrect label size setting. Ensure the label size is set correctly in the labeling software or program. * Labels stuck inside the printer mechanism near the sensor area. Remove any stuck labels.
General| Operating Temperature | 41°F to 104°F (5°C to 40°C) |
|---|---|
| Print Method | Thermal Transfer / Direct Thermal |
| Resolution | 203 dpi |
| Memory | 8 MB Flash |
| Processor | 32-bit RISC |
| Communication Interface | USB 2.0 |
| Core Diameter | 1" (25.4 mm) |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Storage Temperature | -4°F to 122°F (-20°C to 50°C) |
| Certifications | CE, FCC, RoHS, UL, TUV, CB, CCC |
| Operating Humidity | 25-85% non-condensing |
To Next Page
