TSC TX200 Series - Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor

- 38 -
5.5 Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor
Please follow the steps as below.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns green and 5 blinks.
 The LED will be changed as following:
red (5 blinks)  red (5 blinks)  red (5 blinks)  red (5 blinks) 
green (5 blinks)  green (solid)