9
CHAPTER 3
Setting Up the Q-Trak
™
XP Monitor
Installation of Gas Sensors
In addition to the standard built-in sensors, the device can accept up
to six gas sensors.
Install the gas sensors as follows:
1. Ensure the instrument is powered OFF.
2. Remove the sensor module cover.
3. Position the sensor as
shown, making certain the
pins make good contact
with the device. Gas
sensors can be installed in
any available slot. Listen for
a click to confirm sensor is
connected properly.
4. Attach cover to the sensor
module.
5. To configure which sensors
are shown on the display,
refer to Sensors section in
Chapter 5.
To Next Page
Loading...
