30 Q-Trak™ XP IAQ Monitor Model 7585
The units of measure for all PM mass concentration
measurements (PM 1, PM 2.5, and PM 10) are set by the PM
drop-down list. Similarly, the units of measure of all particle
concertation measurements (PC 0.3, PC 0.5, PC 1.0, PC 2.5,
PC 5.0, PC 10.0) are set by the Particle Conc. Drop-down list.
The Notifications/Alarms page
is used to enable and disable
notifications/alarms of the list of
sensors as well as setting their
trigger thresholds. The following
is included in this page.
• Toggle buttons to enable or
disable Notifications /
Alarms.
• Text fields to enter
Notifications / Alarms
thresholds.
• Lastly, to view sensors not
shown on the page, swipe
up and down.
If two or more of the same sensor type is installed, only one will
trigger an alarm.
To Next Page
Loading...
